Home › Furnace filters › GRVM97 / GDVM97
Our script found these filter sizes in the Goodman GRVM97 / GDVM97 source document's filter table: 10x20, 16x25, 20x25. This page is pending human review, so check the source excerpt on the page to see which size applies to your cabinet and return.
Auto-extracted · review pending Filter sizes auto-extracted from the manufacturer document.
| Sizes / part numbers found in the source table |
|---|
| 10 x 20 |
| 16 x 25 |
| 20 x 25 |
Extracted by script from the linked document. Read the excerpt to see which size applies to which cabinet or return.
General guidance (not from this manual): check monthly and replace 1-in. filters every 1–3 months, or follow the filter maker's guidance and your owner's manual.
Pull the old filter and read the size printed on its frame. Nominal sizes are rounded up: a 15.5 x 24.5 in. filter is sold as 16 x 25.
Your furnace manual lists the filter's dimensions, not its MERV rating. Higher-MERV filters restrict more air. Manufacturers such as Carrier recommend keeping the clean-filter pressure drop under 0.2 in. w.c. (ideally under 0.1). Lennox warns that an over-restrictive filter can trip the high limit in winter and freeze the coil in summer. If you want MERV 11–13, a 4-in. media cabinet is the usual route. Ask an HVAC tech to check static pressure. Nominal sizes are rounded: a filter labeled 16 x 25 x 1 actually measures about 15.5 x 24.5 x 0.75.
Manufacturer document for Goodman GRVM97 / GDVM97
Last checked 2026-10-24. Manufacturers revise documents. If your unit's label disagrees, trust the label.
(1) 16 x 25 (1) 16 x 25 (1) 16 x 25 "2) 10 x 20 or (2) 10 x 20 or (2) 10 x 20 or
(bottom) (bottom) (bottom) or
FILTER SIZE (IN²) (QTY) (side or (side or (side or (1) 16 x 25 (1) 16 x 25 (1) 16 x 25
or (2) 16 x 25 or (2) 16 x 25 (1) 20 x 25
bottom) bottom) bottom) (top return) (top return) (top return)
(side) (side) (top return)
Electrical Data
Min. Circuit Ampacity⁴ 8.1 8.1 11.4 14.4 14.4 8.1 8.1 11.4 14.4
Max. Overcurrent
15 15 15 25 25 15 15 15 25
Device (amps)⁵
Shipping Weight (lbs) 118 121 142 144 157 117 122 144 146
¹ Natural Gas BTU/h
² DOE AFUE based upon Isolated Combustion System (ICS)
³ Installer must supply one or two PVC pipes: one for combustion air (optional) and one for the flue outlet (required). Vent pipe must be either 2" or 3" in diameter, depending
upon furnace input, number of elbows, length of run and installation (1 or 2 pipes). The optional Combustion Air Pipe is dependent on installation/code requirements and
must be 2" or 3" diameter PVC.
⁴ Minimum Circuit Ampacity = (1.25 x Circulator Blower Amps) + ID Blower amps. Wire size should be determined in accordance with National Electrical Codes. Extensive wire runs
will require larger wire sizes.
⁵ Maximum Overcurrent Protection Device refers to maximum recommended fuse or circuit breaker size. May use fuses or HACR-type circuit breakers of the same size as noted.
Notes
• All furnaces are manufactured for use on 115 VAC, 60 Hz, single-Our script found these filter sizes in the Goodman GRVM97 / GDVM97 source document's filter table: 10x20, 16x25, 20x25. This page is pending human review, so check the source excerpt on the page to see which size applies to your cabinet and return. 10 x 20; 16 x 25; 20 x 25.
General guidance (not from this manual): check monthly and replace 1-in. filters every 1–3 months, or follow the filter maker's guidance and your owner's manual.
Filter sizes are nominal (rounded). A filter sold as 16 x 25 x 1 actually measures about 15.5 x 24.5 x 0.75 in. Buy by the nominal size printed on the frame.
Manufacturer document for Goodman GRVM97 / GDVM97 (https://cdn.daikincloud.io/PIM/Assets/Documents/SS-FGRVM97_FGDVM97-R32.pdf), last checked 2026-10-24.